"Replaced parts,tested good"

"Customer is experiencing F2E1 error code. I replaced UI and set size,date time."

Unit needs UI assembly. Customer declined any further repairs at this time

"Found food freezing in fresh food section, order control.; ordrng 1 W10867574 (Cntrol)"

Declined service

Rebuilt agitator assembly

Loose nut on float cap Reinstall All op ok

"Pump not starting up , maybe bad harness. Checked wiring harness, going down to drain pump. Found broken black wire to pump. Repaired wiring, harness working.."

Replaced failing R600A compressor. Pressures finally equalized so I returned the evaporator

Unit needs new modules. Customer will let us know.

"Spray arms are not moving.; ordrng 1 W11101428 (Spray arm) and 1 WPW10448645 (Spray arm), used 1 W10195416 (Wheel) from stock"

"Items freezing in the RC ran diagnostic all checked ok, checked unit and found gap in the ice dispenser gasket,ordered replacement ; ordrng 1 WPW10287601 (seal)"

Ice maker stalled put ice maker in harvest filled with water but need to be changed; ordrng 1 W11692144 (Ice maker)

"Gasket torn ice maker over fill, and ice chute close uneven.; ordrng 1 W11189145 (Door chute) and 1 W11557001 (Ice maker) and 1 W10917313 (Gasket)"

Not open. Opens banter 12:45. ; schdld next appmnt for 4/22 TUE PM

Installed pump checked operation ok.

Removed object from blower wheel checked operation ok.

"Installed parts, test it is working properly"

Replaced compressor and condenser with drier.

Replaced control board previous tech ordered unit defrost already.

"Replaced parts , ran and tested unit now fine"

Replaced evaporator motor.

Customers complaint is for not completing cycle and drain pump keeps running and had to unplug and tested unit and pulled up fault code F3E1 for pressure switch issue and ordering main control.; ordrng 1 W11607637 (Control)

Installed door and tests ok at time of service.

Installed heater and thermostat kit and tests ok at time of service.

Replaced defective Capacitor and checkedran diagnostics ; used 1 W11395618 (Capacitor) from stock

I call tech support #7741356364name is Andrew and he said the is too much detergent and they needs to run the clean washer cycle more often He said the unit is working at design ; ordrng 1 W11284522 (Clip)

"Replaced Cam,Actuator and beltRan diagnostics and recalibrated control ; used 1 WPW10006394 (Belt) from stock"

Customer called back and said that local gas company says a high carbon monoxide from oven customer wants new oven called safety to advise Sr 774131261 she said she close out ticket and safety will handle calling the customer

Vd unit needs freezer door (W11604155) needs ext time and 2 man ; ordrng 1 W11604155 (Door)

Customer has not reached out working as designed

"Check found broken gaskets, order parts ; ordrng 2 W10830055 (Gasket)s"

"Replaced parts. Tested ok.; used 1 W10837240 (Idler pulley), and 1 661570V (Belt) from stock"

"Customer states the vegetables are too cold, Check found they stock in the shelves but not inside of the crisper pan, instruct customer to put them inside of the crisper pan."

"Made checks found unit leaking at the heat exchanger, called tech line, unit is being replaced instructed customer SR#7741360285"

"Not draining found clog drain pump,remove clothe from drain pump test ok..paid full balance $352.70#22505942258"

"Found defective LED ,control and switch, replaced and check unit ok."

"Replaced OL in line L1 fuse & ACU all functions restored, tests ok."

"Checked out the recon,founded the failure of the start relay,burned out.Installed the start device relay from the truck stocks,unit tested ok as designed.; used 1 8201786 (Start device) from stock"

TB- Intermittent frozen fill tube. Needs replacement control and UI.; ordrng 1 W11224256 (Control) and 1 W11636544 (UI)

The drain pump is damaged Need controlThe unit is full of water Need drain pump 2 ct; ordrng 1 WPW10661045 (Pump)

"Unit needs new relay ccu and burners switches , labor 205.00 plus part and tax ; ordrng 1 W10888661 (Ccu 299.12) and 2 W10269460 (Switch 28.40)s"

"Found a broken door switch, installed bone, test it is working properly ; used 1 W11123941 (Door switch) from stock"

"Unit needs new ventilation damper , labor 174.00. Plus part and tax ; ordrng 1 WPW10594329 (Damper 143.54)"

Door switch broken. Changed part. Unit ok. ; used 1 WP3406107 (SWITCH) from stock

Replaced console

"F0-e2 over sudsF0-e5 off balanced loadF5-e3 unlock failure F5-e2 lock failure F9-e1 long drain Customer stated that the unit was full of water and she could not use the unit. When I arrived the unit was empty and unlocked but with wet cloths in it. From there I extracted error codes. After that I checked the drain pump catch and that was empty. From there I checked the pressure hose and that seemed ok. I ran auto test cycle and that tested out good and did not cause any new error codes. After that I cleaned all the dog hair out of the bellow since all the drain holes were clogged up. After that I called whirlpool technical and discussed some finding with them. Whirlpool stated there biggest problem is that they need a Comercial unit since they have a dog training business so they should have a Comercial unit, as well that they are using to much detergent because they have a water softener. After all that I put the cloths that were in the unit when I arrived and I ran a quick cycle, showed the customer how much soap bubbles were in it without putting and detergent in it. At the end of the cycle the unit spun out and the cloths seem dry however there was a lot of soap in the drum at the end of the cycle. From what I can tell the unit seems to be working as designed now however the unit should be run through clean cycle with a fresh at least once if not twice. Customer paid service call with credit cardRob sr#7741358707"

Adjust loose rotor run test check ok

Spoke with the customer and she is in the hospital with a new born. She said she would call back to reschedule when she is ready

Washer was pull out from little space found drain hose kink drain ok

"Replace gearcase assembly and stator assembly , unit is working to specifications"

Tested and found washer running as design customer have another washer next to each other if use both at the same time new washer shows low flow I will call customer in the afternoon to make sure its all ok

"Checked and found unit not dispensing water due to a bad filter installation, reinstalled it, checked, unit is working ok now."

Damaged harness.; ordrng 1 W11643701 (Harness)

"Checked and found unit with multiple errors and taking water when not in use, ordered parts ; ordrng 1 W11614515 (Valve) and 1 W11614514 (Control)"

Connection on motor was loose repaired checked operation ok

After inspecting the unit I found the temps needed to be adjusted a few degrees higher to prevent freezing inside.

Damaged inlet valve.; ordrng 1 W11595805 (Valve)

"Sr# 7741360798 kirt , will replaced front left burner switch but it does not guarantee that the burner will last longer on than what its right now ; ordrng 1 WP3148952 (Switch) and 1 W11396790 (Element) and 1 WP3149400 (Switch)"

Damaged pressure switch Scode S153EB; ordrng 1 W11608056 (Control)

Need to check for leaks ; ordrng 1 W11506635 (Coupling) and 1 W11109499 (Drier)

Helper complete

TB- Needs new door seal.; ordrng 1 W11310035 (Seal)

Wash motor pump replaced unit tested ok

TB- Needs replacement shocks. 2 job count return!!! Reschedule same day as #1284560.; ordrng 4 W11316766 (Shock)s

Replace cracked igniter

"TB- Office did not set call up correctly. Should have been rescheduled with replacement control as per last tech visit. Wasted trip, needs control.; ordrng 1 W11740022 (Control)"

"F.f. section still freezing. Called tech line(SR# 7741358183), performed readings, at this time reading normal. Reschedule, 2 count, to perform same ones; schdld next appmnt for 4/21 MON !"

"Found code F5E2 F3E1 Need control electric,latch and pressure 2 ct; ordrng 1 W11029153 (Control electric) and 1 WPW10443885 (Latch) and 1 WPW10448876 (Pressure switch)"

Upper rack adjuster replaced unit tested ok; used 1 W10712395 (Adjuster) from stock

Checked unit and found it is working as designed. Educated customer on how to use it.

"Water line kinked to icemaker(see picture in SD-Mobile), unable to repair. O&i part. 2 count, 2 men. Customer aware that we cannot discard door once replaced; ordrng 1 W11604155 (Frz. Door S.S.)"

Drain pump defective order parts needed.; ordrng 1 W10919003 (Drain pump) and 1 W11481722 (ACTUATOR)

Replaced both f.f. door assemblies

Install part check ok.

"Along with tech CL, replaced both upper f.f. door hinge assemblies"

Unit tested and checked gasket needed for repair ordering part to complete repair.; ordrng 1 W10830055 (Gasket)

Unit need new control board and control panel; ordrng 1 W11449117 (Control panel)

Only received 1 shock. Need all four shocks. ; ordrng 3 W11094464 (Shocks)s

Helper job completed

LH hinge broken.Order parts.; ordrng 1 W11712995 (Hinge LH) and 1 W11712996 (Hinge RH)

** Allow 2 men 2 counts ** Tech Support Service Reference# 7741268805 F4E9. Main relay stored in error codes. Tech support recommended replacing ACU ; ordrng 1 W11707196 (Acu)

Tightened agitator. Calibrated machine. Ran quick service test. All functions normal no errors

Replace front panel and other parts check ok

Adjusted temperature settings

"Made checks found defective console and gasket, console is no longer available, customer wants to repair unit self"

Customers complaint is for leaking water onto kitchen floor and tested unit and couldnt duplicate issue and told customer to test.

"Made checks customer had water in the off position, turn on tested ok, instructed customer"

Cooktop right side frame and control panel right side end cap damaged New construction ; ordrng 1 W11750426 (Frame cooktop) and 1 W11730070 (End cap stnss)

"Made checks found defective cover assembly, ordering part..; ordrng 1 W11395639 (Cover assembly)"

Check found lower harness broken will order ; ordrng 1 W11643701 (Harness)

"Made checks unit functions normal at this time, instructor Customer, still under one year manufacturers warranty"

Damper assy noisy and RS door seal torn. Changed both parts. Unit ok.

"Replace defective parts, tested ok; used 1 W11574181 (THRMST-FIX) from stock"

Felt seal and drum rollers and bearings all damaged needs to be replaced ; ordrng 1 WP3394508 (Bearing) and 1 349241T (Drum rollers) and 1 279735 (Drum seal) and 1 WPW10359270 (Roller shaft) and 1 WPW10359269 (Drum roller shaft) and 1 279220 (Felt pad) and 1 279264 (Front bearing) and 1 W10828351 (Filter)

Installed parts unit test ok

Adjusted unit freezer fan left unit working as designed

Installed parts unit test ok

Unit oven not working and giving f3E1 code ; ordrng 1 W10877013 (Ccu) and 1 WPW10546238 (Valve) and 1 WPW10324738 (Igniter)

Vent pipe is clogged instruct customer needs to be clean unit test ok